Lucent Technologies SLC ConnectReach User & Service Manual page 272

Access system
Table of Contents

Advertisement

Installation
Interface Card Installation
Optional Circuit Card Installation
(Continued)
DSP or Fractional
T1/DSP
combination
circuit card
installation
procedure
(continued)
5-20
Issue 4
June 2002
Step
Procedure
10
Reposition the jumper block over the left side of block P31 (refer to the
following figure).
11
After the DSP or fractional T1/DSP combination circuit card has been
installed, slide the bottom tray/front panel assembly back into the cover.
12
Install the screw in the front panel.
13
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
363-208-050

Advertisement

Table of Contents
loading

Table of Contents