Lucent Technologies SLC ConnectReach User & Service Manual page 496

EZ Config
Using EZConfig
Using EZConfig
Initial Configuration of the SLC
ConnectReach System
Introduction
Procedure
E-4 Issue 4 June 2002
Only the most commonly used settings are available in EZConfig. If the settings
required for an HTTP connection to the NOC are not included in the EZConfig
menus, the SLC ConnectReach system will need to be configured using the meth-
ods described in 4, "Configuring the SLC® ConnectReach™ System."
Action/Prompt/Response
1. To begin
configuring the
SLC
ConnectReach
system, select T1/
Voice
Configuration.
Screen Display
363-208-050
(Continued on next page)