Lucent Technologies SLC ConnectReach User & Service Manual page 361

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Displaying Statistics for a T1 Interface
(Continued)
Clearing loopback
on a T1 line
Displaying usage
report
The clearloopback command is used to clear a loopback that has been
established on a T1 line.
At the statistics:T1 prompt, enter the clearloopback command and the
appropriate parameters for a T1 line from the following table.
Enter this command at the
Statistics:T1 prompt ...
clearloopback
For example:
statistics:T1)> clearloopback network line
The usageReport command is used to see a display that compares the relative
amounts of data and voice usage of the current line to the SLC ConnectReach
system. The default time period is 8 hours.
At the statistics:T1 prompt, enter the usageReport command and specify the
number of hours if different from the default of 8 hours.
For example:
(statistics:T1)> usageReport 4
...and specify this T1 line
parameter...
network, fractional
363-208-050
...and this parameter
payload, line, AIS
(Continued on next page)
7-27
Issue 4 June 2002