Lucent Technologies SLC ConnectReach User & Service Manual page 149

Access system
Table of Contents

Advertisement

®
Configuring the SLC
ConnectReach
Using the Configuration Commands
Configuring Digital Trunks (Continued)
Key commands
(continued)
System
Signaling
The SLC ConnectReach system supports loop-start,
ground-start, or conversion from E&M trunk signaling
to loop- or ground-start. The SLC ConnectReach
system also provides an unconfigured option for
signaling that is absent. If the E&M option is selected,
then the following E&M signaling commands must be
defined:
NOTE: In the SLC ConnectReach system, references
to E&M signaling refer to a signaling type supported
on DID trunks. It does not refer to the E&M signaling
used over metallic leads with older transmission
equipment.
E&M-type-
incoming
E&M-type-
outgoing
Direction
This command provides three options: incoming (calls
from the CO), outgoing (calls to the CO), and two-way
(calls from and to the CO). The incoming option
specifies that analog lines can only receive incoming
calls, but cannot originate calls.
Incoming-routing This command specifies the routing options for
incoming calls. If you select the DID-dialed number
identification service (DNIS) or automatic number
identification (ANI)-DNIS option, the incoming digits
are collected by the SLC ConnectReach system and
routed to the appropriate analog line. Selecting the
line or group option allows an incoming call to be
routed to a line or a group of lines, respectively.
Signaling for incoming E&M trunks is
configured to comply with the signaling mode of
the provider. There are four options: wink start
(wnk-s), immediate start (imm-s), delay dial
(dly-d), and wink delay (wnk-d). With the wink
delay option, the off-hook signal for incoming
calls is delayed until the PBX is connected and
"listening."
Signaling for outgoing E&M trunks is configured
to comply with the signaling mode of the
provider. There are three options: wink start
(wnk-s), immediate start (imm-s), and delay dial
(dly-d).
(Continued on next page)
Issue 4
363-208-050
June 2002
4-63

Advertisement

Table of Contents
loading

Table of Contents