Lucent Technologies SLC ConnectReach User & Service Manual page 163

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Lines (Continued)
Procedure
™
System
After you have verified the required configuration, follow these steps to configure
lines:
Step Procedure
At the Config prompt, enter the Line command:
1
(config)> Line
The prompt changes to the Config:Line prompt.
config:Line)>
(
2 Use the begin and end commands to specify the line or range of lines to which
subsequent changes will apply.
NOTE:
The channel numbers specified in the begin and end commands
refer to the voice channels (lines) on the VOICE CHANNELS port
(50-pin telephony type connector). A foreign exchange station
(FXS) type voice interface card should be used for these channels.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-77