Lucent Technologies SLC ConnectReach User & Service Manual page 371

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Displaying Statistics for the WAN Frame
Relay Interface (continued)
Introduction
(continued)
Display Field
LMIState
TotalStatEnqTx
TotalStatRespRx
FullStatEnqTx
FullStatRespRx
InvalidLMIMsgsRx
LastSeqNumRx
LocalSeqNum
SeqNumSyncErrors
State
MTU
Bandwidth
TxFrames
TxOctets
TxFrameFails
TxErrorStatus
RxFrames
RxOctets
RxErrorFrames
RxOverruns
RxCrcErrors
RxLengthErrors
The fields displayed, and the corresponding MIB fields, are described in the
following table.
Frame Relay Interface Statistics Descriptions
Corresponding MIB Field
frDlcmiState
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Interface/Driver Status
ifAdminStatus,
ifOperStatus
ifMtu
ifSpeed
ifOutUcastPkts
ifOutOctets
ifOutDiscards
N/A
ifInUcastPkts
ifInOctets
ifInErrors
N/A
N/A
N/A
Description
LMI Status
State of LMI over the Link:
UP — LMI configured and communicating with far-end
DOWN — LMI configured, but not communicating with
far-end
Inactive — LMI not configured
See RFC-1315 for details
Total Status Enquiries sent
Total Status Response Messages received
Full Status Enquiries sent
Full Status Response messages received
Number of invalid LMI messages received
Last sequence number received
Local sequence number
Sequence number error count
Interface status
Maximum Transfer Unit
Interface Data Rate in kilobytes per second
Number of packets transmitted for this interface
Number of octets transmitted for this interface
Number of discarded transmit packets for this interface
Number of Transmission errors for this interface
Number of packets received for this interface
Number of octets received for this interface
Number of packets received in error for this interface
Number of receive overruns at the driver
Number of receive CRC errors from driver
Number of receive frame length errors from driver
363-208-050
7-37
Issue 4 June 2002