Lucent Technologies SLC ConnectReach User & Service Manual page 296

Installation
Connect Cables to the SLC ConnectReach System
Procedures (Continued)
Connect the unit
for power
(continued)
5-44 Issue 4 June 2002
Step Procedure
8 Install the retaining bracket for the POWER connector.
9 Reinstall the 6-32 nut and tighten.
10 AC Plug the AC power supply into a grounded 120-V AC receptacle.
DC Connect the DC power cable to the battery, the DC supply, or the
battery backup unit.
NOTE:
If the Model LT733 AC-to-DC power converter with battery backup
is used in powering the SLC ConnectReach system, refer to the
Gordon Kapes, Inc. Technical Practice for the Model 733 DC UPS
Power Supply for information concerning the installation and
connection of this unit.
363-208-050
(Continued on next page)