Lucent Technologies SLC ConnectReach User & Service Manual page 216

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Default Firewall
(Continued)
Procedure for
default IP filter
firewall
4-130 Issue 4 June 2002
™
System
To configure the default IP filter firewall, proceed as follows:
Step Procedure
1 At the Config prompt, enter the firewall command:
(config)>
firewall
The prompt changes to the Config:IPFirewall prompt.
(config:IPFirewall)>
2 At the Config:IPFirewall prompt, enter the default IP filter command:
(config:IPFirewall)>
The prompt changes to the Change prompt.
Change Firewall config to the default 'Outgoing
IPFilter only' settings?>[n]y: y
Enter 'y' to set the default IP filter.
The prompt changes to the Config:IPFirewall prompt.
(config:IPFirewall)>
3 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT).
NOTE:
The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
default ipfilter
363-208-050
(Continued on next page)