Lucent Technologies SLC ConnectReach User & Service Manual page 425

Software Upgrade, Maintenance, and Trouble Clearing
Maintenance Procedures
Upgrading the SLC ConnectReach System
with New Software (Continued)
Software upgrade
from the network
(continued)
Step Procedure
5 At the network-upgrade prompt, enter the prepare command:
(Network-upgrade)> prepare
6 The SLC ConnectReach system asks you to confirm that you want to
perform a warm restart and enter maintenance mode. Enter "y."
While the unit is in maintenance mode, data traffic from the local area
network (LAN) to the wide area network (WAN) and vice versa is blocked
in order to free enough memory to accommodate the download.
7 When the SLC ConnectReach system boots in maintenance mode, you
are prompted for your login name and password. Enter the carrier login
name and password.
8 At the Main Menu prompt, enter the network-upgrade command:
> network-upgrade
9 Execute the download:
(Network-upgrade)> download
Stop! End of Procedure.
After the download completes, the SLC ConnectReach system saves the software
in the system image partition of Flash memory and performs a warm restart.
To download from Lucent Technologies' FTP site directly to the SLC
ConnectReach system, set the parameters as shown in the following figure.
Setting the version command to rel will ensure you download the most current
software.
363-208-050
(Continued on next page)
Issue 4 June 2002 9-11