Lucent Technologies SLC ConnectReach User & Service Manual page 210

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring NAT and PAT (Continued)
Procedure
4-124 Issue 4 June 2002
™
System
Step Procedure
3 PAT Submenu Commands
cont.
1. To configure PAT for a UDP port, number 312, and a default
HTTP port, for example, enter the following commands:
(config:NAT:Dynamic:Group1)> session add udpport 312
192.168.0.3
(config:NAT:Dynamic:Group1)> session add http 312
192.168.0.5
Enter this
command...
session
Show-pat-config
Clear-pat-config
Help
* Examples: Default name and port number: session
192.168.0.3 Keyword: session add pop2 192.168.0.5
The supported keywords are: Telnet, FTP, SMTP, HTTP, Icmp, Tftp, bootp,
gopher, DNS, SNMP, OSPF, NFS, FTP-data, RSVP, NHRP, POP2, and POP3.
...and specify this
value Comments
Adds or deletes a port address as
related to a protocol - specify the
protocol you are configuring, either
by entering the default name and
port number for that protocol (if you
know it), or the keyword (e.g., pop 2,
pop3, http, ftp, telnet)
add/delete
the IP address of the T1 port of the
[protocol port,
appropriate server, inside the
keyword]
inband range (In-start to In-end).
[InbandIPAddress]
Shows protocols and connected
ports.
Clears PAT settings
Access online assistance
363-208-050
*
. Then enter
add udpport 312
(Continued on next page)