Configuring Extensions - Lucent Technologies SLC ConnectReach User & Service Manual

®
Configuring the SLC ConnectReach
Using the Configuration Commands

Configuring Extensions

Introduction
Key commands
™
System
The extension menu associates phone extensions with analog lines. This menu is
primarily used for line to line calls within the premises.
The map extensions menu may also be used to route incoming DID calls. Refer to
the section entitled "Configuring Digital Trunks", discussed previously in this
chapter.
The extension command is included in the LCR/DID telephone functionality
mode and the extension menu will appear only when the LCR/DID optional
feature is installed in the SLC ConnectReach system. In the LCR/DID mode
additional configuration menus, including the extension menu, are used to specify
call routing and DID operation.
NOTE:
The channel-bank menu must be used in conjunction with the extension
menu.
The key commands for the SLC ConnectReach systems's map extension menu
are as follows:
Extension-digits
Set-line
Clear-line-
extension
The show-extension-map command displays the map extension database
entries.
This command specifies the number of extension
digits to allow for each extension and must be the
same as the number specified in the DID-received-
digits command in the Dialing menu.
This command assigns an extension number to a line
with the option of an alternate extension. All extension
and alternate extension numbers must be unique.
This command allows the clearing of any line in the
extension map database. The confirm option will
bypass the prompt, "Do you really want to clear the
extension and alt-extension of line n?"
363-208-050
(Continued on next page)
Issue 4 June 2002 4-87