Lucent Technologies SLC ConnectReach User & Service Manual page 350

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Displaying Statistics for Interfaces
(Continued)
Example of
interfaces statistics
report (continued)
7-16
Issue 4 June 2002
The report contains a section for each available network interface on the SLC
ConnectReach system. Each section begins with a code identifying the interface
the section describes. The possible codes are shown in the following table.
Code Interface
cpm0-0 10Base-T
10Base-T
lo
Network T1/DSX-1 [1st frame
relay permanent virtual circuit
(PVC)]
fr 0-29
Network T1/DSX-1 [point-to-point
protocol (PPP) interface]
sppp
Network T1/DSX-1
[high-level data link control
(HDLC) interface]
hdlc
FDL interface
fd1
ATM 0-4 Network T1 (RFC 1483 pvc)
If you are unable to make a data or voice connection across the SLC
ConnectReach system, check the Interface statistics to determine which interface
is not functioning. In particular, if the flags line indicates "DOWN" for any interface
you expect to see "UP," check the physical connection for that interface.
Comments
Normal interface to primary Ethernet
network. (cpm0-1 is the secondary Ethernet)
Loopback interface. Always reported, even
when the link is not in loopback mode.
Address shown is the standard loopback IP
address.
Present only if encapsulation is set to frame
relay.
Present only if encapsulation is set to PPP.
Present only if encapsulation is set to HDLC.
Present only if IP over facility data link (FDL)
is enabled
Present only if data PVC is set to RFC 1483.
363-208-050