Lucent Technologies SLC ConnectReach User & Service Manual page 92

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Making Connections to the SLC
ConnectReach System (Continued)
Introduction
(continued)
4-6
Issue 4 June 2002
™
System
™
System for Initial
Connect a computer directly to the 10Base-T (Ethernet) port on the SLC
3
ConnectReach system using an Ethernet cross-over cable or connect a
computer to the SLC ConnectReach system 10BASE-T port by means of
an Ethernet hub using a standard cable. For this connection, the computer
must have a network interface card installed. The default IP address
setting for the SLC ConnectReach system Ethernet connection is
192.168.0.1 with a subnet mask of 255.255.255.0. The IP address and
netmask for the TCP/IP protocol of the network interface card should be set
at 192.168.0.2 and 255.255.255.0, respectively.
Once the computer has been configured with the correct IP address to
enable it to communicate with the SLC ConnectReach Ethernet interface,
the SLC ConnectReach system supports the following sessions:
— A Telnet session over the Ethernet using a Telnet application. Once
the Telnet session is initiated, the user interface is identical to the
console session.
— A hypertext transfer protocol (HTTP) session using the Ethernet
interface and a Web browser.
363-208-050
(Continued on next page)