Displaying Statistics For The Frame Relay Interface - Lucent Technologies SLC ConnectReach User & Service Manual

SLC ConnectReach System Monitoring
Using the Statistics Command to Display System
Elements Status
Displaying Statistics for the Frame Relay
Interface
Entering the frame
command
7-32
Issue 4 June 2002
The frame command is used to display a frame relay traffic statistics report.
At the statistics prompt, enter the frame command:
(statistics)> frame
The prompt changes to the statistics:frame prompt where you can enter the
commands from the following table. These let you see statistics for permanent
virtual circuits (PVCs) or local management interface (LMI).
To
Display one or all PVCs
Display LMI
Exit this submenu
If the PVC command is entered with the parameter all, a report similar to the
following example is displayed:
Enter this command...
PVC
LMI
Exit
....and one of these options
(1...30), all
(Continued on next page)
363-208-050