Lucent Technologies SLC ConnectReach User & Service Manual page 227

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring QOS (Continued)
Procedure
™
System
After you have verified the required configuration, follow these steps to configure
QOS:
Step Procedure
1 At the Config prompt, enter the QOS command:
(config)> QOS
The prompt changes to the Config:QOS prompt.
(config:QOS)>
At the Config:QOS prompt, enter the commands from the following table
2
Enter this
command...
enable
qos
Reserved-
Bandwidth
show-qos-table
clear-qos-table
Help
...and specify the baud
rate Comments
Enables QOS
[off], on
Add and delete priority routes.
add, delete
Include IP address and
src [net mask]
netmask.
dst [net mask]
Set reserved minimum
bandwidth. If set to zero, QOS
is set for strict priority.
[0] (kbits/sec)
Displays all priority routes.
Clears all priority routes.
Access online
assistance
(Continued on next page)
Issue 4 June 2002 4-141
363-208-050