Configuring Digital Trunks - Lucent Technologies SLC ConnectReach User & Service Manual

®
Configuring the SLC ConnectReach
Using the Configuration Commands

Configuring Digital Trunks

Introduction
Key commands
4-62 Issue 4 June 2002
™
System
The digital-trunk table defines DID and trunk signaling commands for each digital
trunk (DS0).
The digital-trunk command is included in the LCR/DID telephone
functionality mode and the digital-trunk menu will appear only when the LCR/DID
optional feature is installed in the SLC ConnectReach system and the
ClearReach feature is not enabled. In the LCR/DID mode, additional configuration
menus, including the digital-trunk menu, are used to specify call routing and DID
operation.
NOTE:
The channel bank menu must be used in conjunction with the digital-trunk
menu.
The key commands for the SLC ConnectReach system's digital-trunk menu are
as follows:
Begin and end
Group
The SLC ConnectReach system uses a template
mechanism to set groups of DS0s and associated
options within a given menu. For any given menu, the
template is applied to a range of channels defined by
the begin and end commands.
The begin and end commands determine the range
of channels to be configured. Channels may be set
individually or in groups of similar configuration. The
copy-to-channel-data command copies the
configuration template commands to the channels in
the range between begin and end. If you are
accessing the SLC ConnectReach system by means
of the console or Telnet, you must use the copy-to-
channel-data command after modifying the data in
the configuration template. If you do not, the
configuration data for the individual channels will not
be modified. If you are accessing the SLC
ConnectReach system from a Web browser, there is
no copy-to-channel-data command. Instead, the
Update button performs the same function. The
Show-all command displays the data in the
individual channels.
This command specifies the trunk group to which this
DS0 belongs.
363-208-050
(Continued on next page)