®
Configuring the SLC
ConnectReach
Using the Configuration Commands
Configuring DS0 Provisioning
(Continued)
Procedure
™
System
By default, the SLC ConnectReach system software sets the number of analog
voice channels to the number of actual analog ports that are installed. It sets no
channels for data. The range of the four destinations may not overlap each other.
Step
Procedure
1
At the Config prompt, enter the DS0-provisioning command:
(config)> DS0-provisioning
The prompt changes to the Config:DS0-provisioning prompt
[(config:DS0-provisioning)>].
363-208-050
(Continued on next page)
Issue 4
June 2002
4-33