Lucent Technologies SLC ConnectReach User & Service Manual page 237

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring SYSLOG (Continued)
Sample
™
System
This message would appear in the implementation of a SLC ConnectReach
system SYSLOG as shown in the following table.
Sample SYSLOG message
# Priority/Severity
1. User.Info
The messages in the following table are a typical log. Note that the PRI value is
interpreted (PRI=16 is displayed as User.Info, for example), and that the
hostname value is, in the messages displayed, the IP address of the source IAD.
Log Message
Jan 11 12:22:14 Cust-X-1 conf: Command 'DHCP'
(Continued on next page)
Issue 4
363-208-050
June 2002 4-151