Lucent Technologies SLC ConnectReach User & Service Manual page 198

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Routes
Introduction
Key commands
4-112 Issue 4 June 2002
™
System
The Route menu of the SLC ConnectReach system allows the user to set a
default route and up to 30 static routes. IP routes can also be obtained
dynamically through routing information protocol (RIP) which is enabled in the
Ethernet, Frame Relay, PPP and HDLC menus.
The following table provides a list of the Route configuration key commands.
Enter this command...
route
default
backupDefault
show-static-routes
clear-static-routes
Help
The following is a description of the Route configuration key commands:
Default
...and specify this value
add, delete
net mask
WAN, PVCn, FDL,
GW [IPaddrOfGw]
[WAN], PVCn, IPaddrOfGw,
none
[WAN], PVCn, FDL,
IPaddrOfGw, none
The most common use of this command instructs the
SLC ConnectReach system to send all nonlocal traffic
to a WAN interface. For ease of use, the user can
simply enter default WAN from the Route menu. This
command would instruct the SLC ConnectReach
system to send all the default IP traffic to either PVC1
(for frame relay encapsulation), PPP, or HDLC. The
default WAN command adjusts itself to whatever
synchronous encapsulation is chosen by the user. For
frame relay encapsulation, the user can also select
any of the five PVCs. Selecting PVC1 with frame relay
encapsulation is the same as selecting WAN.
363-208-050
Comments
Add and delete static routes
(including net mask and
PVC or IP gateway).
Enter IP address of the
primary WAN interface.
Specify an interface to be
used as a backup to the
default
Displays the static route
table.
Clears the static route table.
Access online assistance.
(Continued on next page)