Lucent Technologies SLC ConnectReach User & Service Manual page 171

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Lines (Continued)
Feature codes
description
(continued)
Lines Show-all
Response
™
System
Cancel call
forward
Pager
Digital direct
access
Analog direct
access
Cancel busy
redial
To return the feature codes back to their default settings type default. To access
online assistance, type Help.
The show-all command for channel-bank lines displays all configuration
information for each channel-bank line on the SLC ConnectReach system. The
display will appear in the format of the example shown in the following figure.
The following figure shows the Lines Show-all display.
This feature code disables call forwarding.
The pager feature allows for paging capability by
dialing the pager feature code. A commercial off-the-
shelf product is used for the paging amplifier (for
example, Valcom V-2001A Paging Unit).
This feature is used for diagnostics. The direct trunk
select feature, in the BOX submenu, must be enabled
for the digital direct access to function. The user may
enter the digital direct access feature code followed by
the trunk number to test a specific trunk.
This feature is similar to digital direct access only for
analog trunks and lines.
This feature is used when a line is given a busy signal
when dialing another line or when seizing an outgoing
trunk.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-85