Lucent Technologies SLC ConnectReach User & Service Manual page 214

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Default Firewall
(Continued)
Default
configurations
Firewall
configuration
commands
4-128 Issue 4 June 2002
™
System
The default-configure command allows the user to define one of the
following four standard IP firewall configurations:
IP filter
3
IP filter plus server.
3
In the above default commands, the default IP filter methods only allow outgoing
connections to be initiated from the PCs on the LAN. (No connections from the
Internet to the PCs on the LAN can be made.)
If you want to use the NAT application with "IP filtering plus server", you must set
up a static group with "allow-inbound enabled" for the server in NAT.
NOTE:
The default server supports the following services: SMTP, POP2, POP3,
HTTP, FTP, DNS, Telnet, and PING.
The following table lists the standard firewall configuration commands.
Enter this command...
InIPFilterGroup
OutIPFilterGroup
Default-configure
show-config
Help
NOTE:
To totally disable the firewall, give the following command:
(config:IPFirewall)> default no
...and specify the commands
1...4
1...4
IPFilter, No [server] [x.x.x.x]
1...4
1...4
363-208-050
(Continued on next page)