Preparing The Slc ® Connectreach ™ System For Initial Configuration; Equipment Required To Set Up The Slc Connectreach System - Lucent Technologies SLC ConnectReach User & Service Manual

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Preparing the SLC
System for Initial Configuration
Equipment Required to Set Up the SLC
ConnectReach System
In order to initially configure the SLC ConnectReach system, you will need the
List of required
following components and equipment:
equipment
* IBM is a registered trademark of the International Business Machines Corporation.
† UNIX is a registered trademark in the United States and other countries, licensed exclusively through X/Open
Company Limited.
4-4
Issue 4 June 2002
™
System
™
System for Initial
®
ConnectReach
A SLC ConnectReach system unit with a 120 V AC power supply
3
transformer and power cord or a DC power cord.
A computer equipped with a terminal emulation application for null modem
3
or dial up modem connections. This can be an IBM
computer (PC) running an application such as HyperTerminal, or a UNIX
workstation running tip, or any computer running a similar application. The
Telnet application is used for Ethernet connections.
A connection between the SLC ConnectReach system and a computer
3
terminal that can be accomplished in one of the three following ways:
— A modem and cable for remote connection.
— A null modem cable to connect to the serial port of a local computer
terminal. For information about the pin assignments on the RS-232
connector, refer to Chapter 5, "Installation".
— An Ethernet cross-over cable to connect to the Ethernet port on a
computer equipped with an Ethernet card (required only when a PC
is being connected to the SLC ConnectReach system 10BASE-T
port). A PC can also be connected to the SLC ConnectReach
system 10BASE-T port by means of an Ethernet hub using a
standard cable.
If the SLC ConnectReach system is being configured from the craft
3
interface terminal (CIT) at the SLC-2000 RT/HDT, the following
connections must be made:
— The T1 connection must be made at the SLC ConnectReach system
NETWORK T1 LINE port
— The CIT must be connected to the CIT connector on the SLC-2000
RT/HDT user interface panel (UIP).
™
363-208-050
*
-compatible personal
†