Lcr/Did Configuration Example - Lucent Technologies SLC ConnectReach User & Service Manual

Configuration Examples
Examples of the Different Methods of Configuring the
® ™
SLC ConnectReach System

LCR/DID Configuration Example

Quickstart
assumptions
Configuration
setting example
* Registered trademark of VINA Technologies, Inc.
B-14
Issue 4 June 2002
The local call routing/direct inward dial (LCR
the following assumptions:
One or more DS0s on the Network T1/DSX-1 connect to a long distance
3
carrier.
At least one foreign exchange office (FXO) card is present, and it is used to
3
connect to a local carrier.
If these assumptions do not apply to your configuration, refer to Chapter 4,
®
"Configuring the SLC ConnectReach
The following is an example of the procedure for configuring the SLC
ConnectReach system in the LCR/DID mode:
1. Go to the config/Network menu. Set enable to ON. Set framing to ESF.
Set linecode to B8ZS. Set clock to network.
2. Go to the config/DS0 menu. Set analog-begin and analog-end to the
first and last DS0 numbers used for digital trunks. Use the ConnectReach
command to assign channel units to designated DS0 channels.
3. Go to the config/channel-bank menu. Set signaling to unconfigured.
Use the copy-to-channel-data command. This takes all voice DS0s
out of channel bank mode.
4. Go to the config/digital-trunk menu. Set begin and end to the first and last
DS0 numbers used for digital trunks. Set signaling to match the trunk
type as configured in the central office. Inspect the other parameters for
accuracy. In most cases, they will not need modification. Use the copy-
to-channel-data command. This puts the selected range of DS0s into
LCR/DID mode and configures them as digital trunks.
5. Go to the config/analog-trunk menu. Set begin and end to the first and
last cable pairs on the voice channels connector used for analog trunks.
Set signaling to match the trunk type as configured in the central office.
Inspect the other parameters for accuracy. In most cases, they will not
need modification. Use the copy-to-channel-data command. This
configures the analog trunks.
*
/DID) telephony quickstart makes
™
System", for more detailed instructions.
(Continued on next page)
363-208-050