Lucent Technologies SLC ConnectReach User & Service Manual page 183

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Voice Mail
Introduction
Key commands
™
System
The optional BOX features, when installed, communicate with a voice mail system
using dial tone multifrequency (DTMF) inband signaling. The voice mail system,
typically, is located near the SLC ConnectReach system and is attached by
means of the FXS line(s). One or more lines are dedicated to the physical voice
mail ports. There are five preset voice mail profiles to choose from. Custom
configuration is also possible. The SLC ConnectReach system can be configured
to forward incoming trunk calls to a voice mail system providing auto-attendant
functions.
The key commands for the voice mail menu are as follows:
Line-group
Integration-delay This command sets the delay between the initial call to
Stutter-tone
Periodic-ring
Dial-number
Profile-name
This command specifies the line group designated for
the voice mail system.
the voice mail system and the sending of the DTMF
string.
If this command is enabled, the user will hear a
stuttering dial tone when they pick up the receiver
indicating there are messages waiting.
If this command is enabled, the phone will give two
short rings every 5 minutes indicating there are
messages waiting.
This command is used to assign a unique extension
number for accessing the voice mail system.
A name may be assigned to the configured voice mail
settings. Any alphanumeric name up to 20 characters
in length is acceptable.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-97