Lucent Technologies SLC ConnectReach User & Service Manual page 105

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Basic Procedure For Using the
Configuration Commands (Continued)
Introduction
(continued)
Basic steps in
configuring and
saving new settings
™
System
Every configuration command has default settings, including IP addresses. The
default settings for each configuration command are displayed on screen in
brackets after you enter a question mark ( ? ) at the Config prompt.
The following steps provide the basic procedure for entering configure commands
and saving the configuration settings:
Step Procedure
1 At the Main Menu prompt, enter the configure command.
> config
Press the ENTER key and the prompt changes to the Config prompt
where you can enter the Configuration commands.
(config)>
2 At the Config prompt, enter the appropriate Configuration commands or
type a question mark (?) for a list of all available commands.
3 After you use the configuration commands, you must save your
configuration settings in nonvolatile random access memory (NVRAM).
To save the configuration settings, enter the save command at the
Config prompt.
(config)> save
NOTE:
If you do not wish to save the configuration settings that you have
entered, you can discard them by using the exit command,
explained in the next step, instead of the save command.
4 Enter the exit command: (config)> exit
If you did not save the configuration settings as instructed in Step 3, you
will receive the following prompt:
Do you really want to abandon your changes? [n]y:
Type y to display the original configuration.
Stop! End of Procedure.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-19