Initiating A Session With The Slc Connectreach System - Lucent Technologies SLC ConnectReach User & Service Manual

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Initiating a Session with the SLC
ConnectReach System
After you have connected a computer or modem to the SLC ConnectReach
From a computer
system, start a serial terminal emulation application to initiate a communications
connected to
session. For example, you can start an application such as tip on a UNIX
RS-232 port
workstation, or HyperTerminal on Microsoft Windows.
Perform the following procedure to initiate a session with the SLC ConnectReach
From the CIT at
system:
SLC-2000 RT/HDT
™
System
™
System for Initial
Step Procedure
1 Press the user interface panel Escape button and then the Scroll Menu
down arrow button until SET-BAUD: <ent> is displayed. Press the user
interface panel Enter button then the Scroll Menu down arrow button
until the desired baud rate is displayed (9,600 is the default for the
terminal emulator software and UIP). Press Enter to set the CIT baud
rate.
2 Turn on the CIT, set the terminal parameters described previously, and
start the CTRM terminal emulator application.
3 Enter a question mark (?) or RETURN.
CIT prompts with:
/* Enter 1 to continue */
subsystem =
4 Enter 1 .
5 The CIT will respond with " login <" (enter LUC01 , LUC02 , or LUC03 )
and " password " (enter SLC-2000 ).
Response: The CIT will display a SONET alarm summary generated by
the rtrv-alm: all command. The CIT will then display a prompt.
6 Move to the DLC subsystem side by entering dlc at the CIT prompt.
363-208-050
(Continued on next page)
4-11
Issue 4 June 2002