Lucent Technologies SLC ConnectReach User & Service Manual page 134

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Synchronous Interface
(Continued)
Using the PPP
commands
Using the HDLC
commands
4-48 Issue 4 June 2002
™
System
At the Config:Synchronous-interface prompt, enter the Modify-encap-data
command to access the PPP commands listed in the following table:
Enter this
command... ...and specify this value Comments
IP-address, Enet*,
IP-address [Disable]
netmask netmask
Enable, RxOnly,
RIP TxOnly, [Disable]
version-RIP [1], 2
Help
* The Enet value assigns the primary Ethernet IP address (IP unnumbered).
At the Config:Synchronous-interface prompt, enter the Modify-encap-data
command to access the HDLC commands listed in the following table:
Enter this
command... ...and specify this value
IP-address IP-address, Enet*,
[Disable]
netmask netmask
RIP Enable, RxOnly,
TxOnly, [Disable]
version-RIP [1], 2
Help
* The Enet value assigns the primary Ethernet IP address (IP unnumbered).
Enter the IP address for the PPP
interface, Enet or disable.
Enter a netmask value, such as
255.255.255.0.
Select the mode of RIP to use.
Select the version of RIP to use.
Access online assistance.
Comments
Enter the IP address for the HDLC
interface, Enet or disable.
Enter a netmask value, such as
255.255.255.0.
Select the mode of RIP to use.
Select the version of RIP to use.
Access online assistance.
363-208-050