Lucent Technologies SLC ConnectReach User & Service Manual page 224

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the DNS Server
Introduction
Procedure
4-138 Issue 4 June 2002
™
System
The SLC ConnectReach system uses DNS servers to resolve host names for
internal commands such as ping and network upgrade.
NOTE:
SOCKS Version 4 requires that the SLC ConnectReach system DNS server
be configured. The DNS proxy server forwards IP domain name resolution
requests from devices on the LAN to the primary DNS server on the WAN,
or to the secondary DNS server on the WAN, if necessary.
To configure the DNS server, proceed as follows:
Step Procedure
1 Obtain the DNS server address(es) from the carrier.
2 At the Config prompt, enter the DNS command:
(config)> dns
The prompt changes to the Config:DNS prompt.
(config:DNS)>
At the Config:DNS prompt, enter the appropriate commands from the
3
following table. The DNS server addresses usually are the addresses of
DNS servers on the WAN/Internet, not the local Ethernet, that are
provided by the Internet service provider
Enter this command...
enable
primary-dns-server
secondary-dns-
server
Help
.
...and specify this
value Comments
off, [on]
Enter the address of the primary
Domain Name Server.
IP-address
Enter the address of the
secondary Domain Name
Server.
IP-address
Access online assistance.
(Continued on next page)
363-208-050