Lucent Technologies SLC ConnectReach User & Service Manual page 174

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Extensions (Continued)
Procedure
4-88 Issue 4 June 2002
™
System
After you have verified the required configuration, follow these steps to configure
the map extension:
Step Procedure
At the Config prompt, enter the map-extensions command:
1
(config)>
map-extensions
The prompt changes to the Config:Map-Extensions prompt.
(config:Map-Extensions)>
Make the necessary configuration changes. The following table describes
2
these commands.
To
Specify the number of
extension digits allowed
Assign an extension and
optionally an alternate
extension to a line
Remove a line entry.
Optional automatic confirm
Display the map extension
database
Access online assistance
3 Use the show-map-extension command to see the actual
configuration.
4 Type exit or an exclamation point (!) (quoted as "\ |" through the
SLC-2000 Access System CIT).
NOTE:
The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
Enter this command... ...and specify the value
extension-digits 1...[2]...10
line # extension #
set-line alt-extension #
clear-line- line # (1...48)
extension confirm
show-extension-map
Help
363-208-050