Lucent Technologies SLC ConnectReach User & Service Manual page 248

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Using Template Archive (Continued)
Procedure
(continued)
4-162 Issue 4 June 2002
™
System
Step Procedure
2 At the config:template prompt, enter the commands shown in the
following table.
Enter this
command...
enable-
template-mode
server-ipaddr
filename
user
upload
download
** If template-archive is to be used with auto-config, the configuration file name must follow the
convention of vinaconfig.serialnum, where serialnum is the serial number of the remote SLC
ConnectReach system.
3 When you have made the necessary configuration changes you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT)
The prompt changes to the Enable prompt.
Enabling the Template-Archive will place this unit in
to the Template-Archive mode. Are you sure you want to
enable this mode?
Spell out "enable" to continue (enter to cancel)>
enable
4 Save the template archive settings by entering the save command. This
will put the SLC ConnectReach system into the template-archive mode.
NOTE:
Once the SLC ConnectReach system is in template-archive mode,
the only menu available is the config menu. To return to the normal
mode, disable the template-archive.
...and specify this
value Comments
Enables the template archive function.
[off], on
IP address of the FTP server
IP address
The file should have a .txt suffix,
unless auto-config will be used on the
*
file name remote SLC ConnectReach system.
A valid username and password for the
FTP server. The prompt for the pass-
word will appear after entering the
name username.
To upload the configuration settings.
To download the specified configura-
tion file from the FTP server to the SLC
ConnectReach system.
363-208-050
.
(Continued on next page)