Lucent Technologies SLC ConnectReach User & Service Manual page 137

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Ethernet Interface
(Continued)
Procedure
(continued)
™
System
Step Procedure
At the Config:Ethernet prompt, enter the appropriate commands from
2
the following table.
Enter this
command...
IP-address
netmask
secondary-ip
sec-netmask
RIP
version-RIP
link-integrity-
test
Help
* This setting turns on detection of conditions such as whether the SLC ConnectReach
System is disconnected from the 10Base-T hub or the hub's power is off. If SNMP is
enabled, and if SNMP messages of this type are also enabled, the SLC ConnectReach
System reports these conditions to the SNMP host.
When you have made the necessary configuration changes, you can
3
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT.)
NOTE: The new command values take effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new values.
Stop! End of Procedure.
...and specify this
value Comments
Enter the IP address of the Ethernet
interface (the default is 192.168.0.1).
IP-address
Enter a netmask, such as
255.255.255.0.
netmask
Enter a second IP address for a
separate logical network on the
same physical network. This is
required for pass-Thru NAT (see
Configuring NAT and PAT on page
4-119).
IP-address
Enter a netmask for the second IP
address.
netmask
Enter the mode of RIP to use for the
primary and secondary IP
Enable, RxOnly,
addresses.
TxOnly,[Disable]
Enter the version of RIP in use.
[1], 2
Enable or disable automatic testing
of Ethernet connectivity.
off, [on*]
Access online assistance.
363-208-050
Issue 4 June 2002 4-51