Lucent Technologies SLC ConnectReach User & Service Manual page 245

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Setting Features (Continued)
Display features
Procedure
™
System
To display features that are enabled, proceed as follows:
Step Procedure
1 At the Config prompt, enter the show features command and press
enter:
(config)> features-show
The following default features are displayed:
Feature bits: 0x000000000000000d
Features enabled: Data, DIDLCR
2 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT)
Stop! End of Procedure.
Feature keys are normally set at the factory. To add new features to the system
after it has been installed, you use the set-features command in conjunction
with the feature key which can be obtained from Lucent Technologies.
To set a feature key, proceed as follows:
Step Procedure
1 At the Config prompt, enter the set-features command followed by
the feature key:
(config)> set-features xxxx-yyyy-zzzz-wwww-cccc
Example: set-features rQ5@-pQ8n-3USr-thLq-he..
NOTE: If you change any of these settings, you must save the
configuration and reboot the SLC ConnectReach system using the
warm-start command for the new settings to take effect.
Stop! End of Procedure.
.
Issue 4 June 2002 4-159
363-208-050