Lucent Technologies SLC ConnectReach User & Service Manual page 200

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Routes (Continued)
Example of default
and static routes
(continued)
Procedure
4-114 Issue 4 June 2002
™
System
To configure the sample route shown in the figure, proceed as follows:
Step Procedure
1 At the Config prompt, enter the route command:
(config)> route
The prompt changes to the Config:IPRoutes prompt.
(config:IPRoutes)>
363-208-050
(Continued on next page)