Lucent Technologies SLC ConnectReach User & Service Manual page 202

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Using ARP
Introduction
4-116 Issue 4 June 2002
™
System
Address resolution protocol (ARP) is a TCP/IP protocol used to convert IP
addresses to physical addresses, such as Ethernet (MAC) addresses. For
purposes of internal testing, you can map a device's IP address or a host server's
address to an Ethernet address temporarily.
NOTE:
Use this mapping with caution and make sure that when your testing is
complete, you clear any mapping that may conflict with those on the
network.
363-208-050
(Continued on next page)