Lucent Technologies SLC ConnectReach User & Service Manual page 120

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring DS0 Provisioning
(Continued)
Procedure
(continued)
4-34 Issue 4 June 2002
™
System
Step Procedure
At the Config:DS0-provisioning prompt, enter the
2
following table and specify the ranges of analog and data channels.
Enter this
command...
analog-begin
analog-end
sec-voice-begin
sec-voice-end
sec-data-begin
sec-data-end
data-begin
data-end
alignment-sec-t1 low
ConnectReach
Help
*
The default setting is low for systems with software release prior to R5.0.1 and
same for systems with R5.0.1 and later.
...and specify
the value Comments
Software automatically detects the number
of voice channels. If no voice channels are
found, 0 is entered.
[n] 0...24
Sets value to the last voice channel
detected.
[n] 0...24
[0] 0...24 For network T1/DSX-1 interface use only.
[0] 0...24 For network T1/DSX-1 interface use only.
[0] 0...24 For network T1/DSX-1 interface use only.
[0] 0...24 For network T1/DSX-1 interface use only.
[0] 0...24
[0] 0...24
If set to the default value, low, the SLC
ConnectReach system connects the
lowest numbered DS0 on the Network T1/
DSX-1 to the first DS0 on the Secondary/
Fractional T1/DSX-1. If set to same, the
DS0s on the Network T1/
DSX-1 are connected to the same DS0
numbers on the Secondary/Fractional T1/
* *
DSX-1.
, same
Allows available channel units to be
DS0 range
designated for DS0 channels and enables/
CU
disables the ClearReach
clearreach
Access online assistance.
363-208-050
command from the
DS0
™
feature.
(Continued on next page)