Lucent Technologies SLC ConnectReach User & Service Manual page 102

®
Configuring the SLC ConnectReach
®
Preparing the SLC ConnectReach
Configuration
Using the SLC ConnectReach System
Utility (Continued)
The following table lists the commands available at the Main Menu prompt.
Using the Main
Menu commands
4-16
Issue 4 June 2002
™
System
™
System for Initial
To...
Display Online Help for the commands currently
available
Configure the SLC ConnectReach system
Display statistics about the SLC ConnectReach
system
Upgrade the SLC ConnectReach system with new
software using the network and to switch the system
into the maintenance mode for xmodem-download
command execution
Upgrade the SLC ConnectReach system with new
software using a modem or direct connection to PC
by means of the RS-232 port
Save the current configuration or retrieve a
configuration from a remote computer
Display version and uptime information
Show the hardware configuration
View a log of events
Display a channel state or set an analog voice
channel to a known state for testing
Check that a device is communicating on the network ping
Trace the route between two points on the network
Reboot the SLC ConnectReach system with minimal
interruption of existing voice connections if T1 feeder
is TR-08. Existing voice calls are dropped if T1 feeder
is TR-303. All data connections are interrupted.
Reboot the SLC ConnectReach system with
interruptions of both voice and data connections
Reboot the SLC ConnectReach system Slave with
minimal interruption of existing voice connections
Reboot the SLC ConnectReach system Slave with
interruptions of both voice and data connections
Get online assistance
Exit the SLC ConnectReach system Utility and
disconnect from the SLC ConnectReach system
* This command available only in systems with R5.0.1 and later.
†
This command available only in systems prior to R5.0.1.
Enter this command...
? (question mark)
config
statistics
network-upgrade
xmodem-download
archive
version
show-hardware-config
log
diagnose
traceroute*
warm-start
cold-start
†
slave-warm-start
†
slave-cold-start
Help
exit
363-208-050