Lucent Technologies SLC ConnectReach User & Service Manual page 143

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Channel Bank Mode
(Continued)
Key commands
(continued)
Procedure
™
System
Loop-gnd-
disconnect-delay This command sets the length of time that a
on-hook-tx
After you have verified the required configuration, follow these steps to configure
the voice channels:
Step Procedure
1 At the Config prompt, enter the channel-bank command:
(config)> channel-bank
The prompt changes to the Config:Channel-bank prompt.
(config:channel-bank)>
2 Use the begin and end commands to specify the range of analog ports
to which subsequent changes will apply.
NOTE: The channel numbers specified in the begin and end commands refer
to the Network T1/DSX-1 DS0s. The range of available DS0s is limited by the
analog-begin and analog-end commands in the DS0 provisioning menu. If the
cross-connect feature is disabled or not available, the lowest available DS0 is
connected to voice channel 1 on the VOICE CHANNELS port (50-pin
telephony type connector). For example, if analog-begin is set to eight in the
DS0 provisioning menu, then channel eight refers to DS0 number eight of the
Network T1/DSX-1 and to the first pair on the VOICE CHANNELS connector.
In order to avoid confusion, it is recommended that you provision your DS0
lines with the voice channels starting at the first DS0. In that case, the analog
ports and DS0 channels always have the same numbers (unless the cross-
connect feature is being used).
disconnect signal must persist on the digital side
before the loop opens on the analog side. The default
setting of 600 milliseconds complies with ANSI
T1.403. Settings between 125 and 500 milliseconds
comply with AT&T Pub. 43801. When the ClearReach
feature is enabled and operational, the lp-gnd-
disconnect-delay operates at 500 milliseconds, and is
not adjustable. The setting displayed here should be
disregarded.
This command enables or disables transmission of
signals over the T1 line when the phone is on-hook. If
enabled, the message light on all on-hook phones
configured will function.
363-208-050
(Continued on next page)
Issue 4 June 2002 4-57