Lucent Technologies SLC ConnectReach User & Service Manual page 144

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring the Channel Bank Mode
(Continued)
Procedure
(continued)
4-58 Issue 4 June 2002
™
System
Step Procedure
Make the necessary configuration changes (see the following table) or
3
use the load-template command to load an existing configuration of a
channel.
To
Set the first channel
Set the last channel
Enter the type of trunk
signaling (input)
Specify the signaling for
incoming E&M trunks
Specify the signaling for
outgoing E&M trunks
Specify the equipment that
is attached to the channel
bank/lines
Disable if not supported by
analog equipment
Disable if not supported by
analog equipment
Adjust transmit gain
Adjust receive gain
Adjust on-hook threshold
Set the tip status for alarm
conditions
Enter this
command... ...and one of these options
Software automatically detects the
number of voice channels. If no
voice channels found, a value of 0
is entered.
begin
Sets value to the last voice channel
detected.
end
[loop-gnd], E&M,
signaling unconfigured
incoming- [wnk-s], imm-s, dly-d,
type wnk-d
outgoing-
type [wnk-s], imm-s, dly-d
[fxs-loop], fxs-ground,
analog- fxo-did, fxo-loop, fxo-
interface ground
far-end-
disconnect disable, [enable]
loop-
reversal disable, [enable]
tx-gain-db 0, [-3], -6
rx-gain-db 0, [-3], -6, -12
on-hook-
threshold 300...[1250]...2000 msec
alarm-state idle, [busy]
363-208-050
(Continued on next page)