Lucent Technologies SLC ConnectReach User & Service Manual page 247

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Using Template Archive
Introduction
Procedure
™
System
The template-archive mode allows a network operator to create a configuration
file with complex functionality using a SLC ConnectReach system chassis with
minimal functionality. This is accomplished by suppressing the warning messages
that normally appear if the necessary hardware is not present. The configuration
is then uploaded as an ASCII text file to an FTP server (configuration server)
using the archive:upload command. The FTP server may have several different
configuration files used as standards for the NOC. These files may be
downloaded to the SLC ConnectReach system using the archive command or
uploaded from the SLC ConnectReach system through auto-config. The auto-
config optional feature is used in conjunction with the template-archive optional
feature.
The template-archive menu is similar to the archive menu in that it will take a
snapshot of the configuration displayed and represent it as an ASCII text file. The
file has two parts:
A listing similar to the config:show command, including the values of all
3
configuration parameters
A hexadecimal representation of the configuration.
3
To configure and use the template-archive menu, perform the following steps:
Step Procedure
1 At the config prompt, enter the template-archive command:
(config)>
template-archive
(Continued on next page)
Issue 4 June 2002 4-161
363-208-050