Lucent Technologies DEFINITY Guide Manual
Enterprise communications server
Hide thumbs
Also See for DEFINITY Guide:
- Installation for adjuncts and peripherals (229 pages) ,
- User manual (202 pages) ,
- Installation manual (144 pages)
Related Manuals for Lucent Technologies DEFINITY Guide
Summary of Contents for Lucent Technologies DEFINITY Guide
- Page 1 ® DEFINITY Enterprise Communications Server Release 6, Issue 2.1 (02.1.125.1) Change Description 555-233-402 Comcode 108286063 Issue 2 May 1998...
- Page 2 Trademarks employees, agents, subcontractors, or persons working on your company’s DEFINITY is a registered trademark of Lucent Technologies in the United behalf. Note that there may be a risk of toll fraud associated with your tele- States and throughout the world.
-
Page 3: Abbreviated Dialing (Ad)
Highlights This change description document describes the changes incorporated in DEFINITY Enterprise Communications Server (ECS), Release 6, Issue 2.1 (02.1.125.1). Platform Offer Category For R6.2, two offer categories are supported. Category A is used for DEFINITY ECS R6 and DEFINITY ProLogix Solutions systems. Category B is used for DEFINITY BCS Issue 4.0 and GuestWorks server Issue 4.0 systems. - Page 4 Announcement Boards The list configuration command did not display translated but uninserted announcement boards properly. AUDIX Transfer AUDIX transfers did not complete when the number of outstanding calls was greater than 31. Now, AUDIX transfers complete when the number of outstanding calls is 32.
-
Page 5: Integrated Services Digital Network (Isdn)
When a bridge of the originating party dropped out of a call that had routed off-net with call classification on a non-ISDN end-to-end trunk, the call was torn down. Now, the call is not torn down, but call classification is terminated, the call is left off-net, and it is not redirected to subsequent coverage. - Page 6 Issue 2 May 1998...
-
Page 7: Index Of Changes
Index of Changes The following lists the item numbers of the features and categories that are affected by the changes, modifications, and enhancements that are described in the next section. Feature or category See item numbers Feature or category See item numbers Call Classification AAR Analysis Form Call Coverage... - Page 8 Index of Changes Feature or category See item numbers Feature or category See item numbers Expansion Port Networks (EPNs)7 Return Call Timer Expert Agent Selection (EAS)19 Routing Feature Access Codes (FACs)48 Send All Calls (SAC) Service Observing Hunt Groups Signaling Skills Incoming Trunk Calls Splitting (ITCS)27 Splits...
-
Page 9: Change Descriptions
Change Descriptions The following problems are corrected and addressed in DEFINITY Enterprise Communications Server (ECS), Release 6, Issue 2.1 (02.1.125.1). 1. When an off-net coverage or forwarded call could not find an available trunk, busy tone was played back to the calling party, effectively ending the call. - Page 10 Change Descriptions 8. Transferring into AUDIX when AUDIX was not explicitly in the coverage path or if a vector was active failed on Intel machines. 9. If both Coverage of Calls Redirected Off-Net and Answer Supervision by Call Classification features were active on an off-net call, the call did not further redirect to subsequent coverage points.
- Page 11 20. A goto time-of-day vector step allowed a combination of “all” with a specific day. 21. The list configuration command did not display translated but uninserted announcement boards properly. 22. LAI routing did not continue down the list of trunks in the route pattern when it received a release complete message immediately following the setup message, even if the correct cause value for LAI routing was present.
- Page 12 Change Descriptions 34. Turning off TTI did not remove ports that were administered by TTI on cabinets that had been removed, causing translation corruption. 35. Automatic caller information was not displayed if the agent was not in the first split that the call was queued to. 36.
- Page 13 disabled for the stations actually on a call requiring an authorization code, and are reenabled when the dialing of the authorization code is completed or abandoned. 47. When a call covered from an EAS agent login ID extension to a station on another DEFINITY ECS over an ISDN DCS+ trunk, the display at the covered-to station showed the physical station name (rather than the agent’s login ID extension name) where the EAS agent was logged in.
- Page 14 Change Descriptions 56. Agents could not remove themselves from a skill (using the feature access code for remove agent skill) without going directly back to the auto-in mode. Attempts to go into the aux-work mode failed and went to the auto-in mode instead.
Need help?
Do you have a question about the DEFINITY Guide and is the answer not in the manual?
Questions and answers