Provision Dt Server From Cit - Lucent Technologies SLC ConnectReach User & Service Manual

®
Provisioning the SLC -2000 RT/HDT
DT Server Preparation, Installation, and Provisioning

Provision DT Server from CIT

Introduction
Determine DT
Server AID
Procedure
6-10 Issue 4 June 2002
This section contains the procedure for provisioning the DT Server channel unit
for use with the channel units located in the SLC ConnectReach system. The DT
Server units that are acceptable for use with the SLC ConnectReach system are
SPQ809, SPQ810, or SPQ811. This procedure assumes that the SLC-2000
Access System is equipped with the enhanced fiber-in-the-loop (FITL) feature that
allows service to 1,152 plain old telephone service (POTS) lines. The enhanced
FITL feature permits a 24-line DT Server card to be installed in MDS slot 1, 5, 9,
13, 17, or 21 and a 12-line DT Server card to be installed in MDS slot 1, 3, 5, 7, 9,
11, 13, 15, 17, 19, 21, or 23. An existing 768-line FITL system can be converted to
the 1,152 enhanced FITL feature using procedures located in document
363-208-001, SLC -2000 Access System, User/Service Manual.
From the work order record detail (WORD) document, determine the DT Server
AID address.
The AID has the following syntax:
dt-Shelf#-CU#
or
cu-Shelf#-CU#
where:
Shelf# : Shelf number {1-8}
CU# : First slot label number in the leftmost slot that the DT Server unit is installed
in {1, 3, 5, 7, 9, 11, 13, 15, 17, 19, 21, or 23}.
example: dt-1-1
Use the following procedure to provision the DT Server card slot:
NOTE:
The DT Server card slot can be provisioned before or after the DT Server is
installed in the MDS.
Step Procedure
1 If necessary, perform the procedure presented earlier in this chapter in
the section entitled "CIT Set Up and Connection" to set up and connect
the CIT.
363-208-050
(Continued on next page)