Cit Setup And Connection; Connect Cit And Set Baud Rate At Uip - Lucent Technologies SLC ConnectReach User & Service Manual

®
Provisioning the SLC -2000 RT/HDT

CIT Setup and Connection

CIT Setup and Connection

Connect CIT and Set Baud Rate at UIP

Procedure Use the following procedure to connect the CIT to the SLC-2000
RT/HDT user interface panel (UIP) and set the baud rate at the UIP:
Step Procedure
1 Obtain the following equipment:
a. IBM * compatible personal computer (PC) running terminal
emulator software using MS-DOS
or later with a serial port.
or
an American standard code for information interchange (ASCII)
terminal.
NOTE:
Refer to the "Ordering" chapter in document 363-208-000,
SLC-2000 Access System, Applications, Planning, and Ordering
Guide, for a partial summary of compatible CIT terminals, PCs, and
modems.
b. RS-232 cable to connect PC Serial port to user interface panel
CIT port.
NOTE:
In this procedure it is assumed you are familiar with the
characteristics and operating procedures of your terminal or PC
and the MS-DOS operating system.
* Registered trademark of International Business Machines Corporation.
†
Registered trademark of Microsoft Corporation.
†
operating system, Release 3.0
(Continued on next page)
Issue 4 June 2002
363-208-050
6-3