Lucent Technologies SLC ConnectReach User & Service Manual page 178

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Dialing (Continued)
Key commands
(continued)
4-92 Issue 4 June 2002
™
System
The following figure provides an example of a detect-
insert table.
The following is an explanation of the detect-insert
table example:
Row 1
Row 2
Row 3
Row 4
Row 5
Output-insert This command requires four values. The first value is
the row number of the output table. The second value
specifies which trunk group to seize. The third value
refers to an alternate-output-row. The fourth value
specifies digits to insert or delete and includes a
pausing capability. The third and fourth values are
optional. For entries with digits and no alternate-
output-row use a "—" (dash).
The digits define the manipulation necessary to
complete the call. The syntax for this entry are as
follows:
Digit
D
P
Detects toll free and 900 number calls
and refers them to output row 3.
Detects United States long distance calls
and refers them to output row 1.
Detects international calls and refers
them to ouput row 2.
Detects local calls, including information,
service repair and emergency calls, and
refers them to output row 3.
Detects credit card calls and refers them
to output row 3.
One of the following: 0 1 2 3 4 5 6 7 8 9
may be inserted at the beginning of the
dialing string (for example, 3).
D deletes the current digit from the
number dialed.
P provides a pause.
(Continued on next page)
363-208-050