Lucent Technologies SLC ConnectReach User & Service Manual page 495

EZ Config
Initial Setup
Initial Setup
Connecting a Palmtop or Laptop to the
SLC ConnectReach System
Requirements
Configuring the
network interface
card
Configuring the
browser
There are two physical requirements to connect a palmtop or laptop to the SLC
ConnectReach system:
An installed network interface card on the palmtop or laptop.
3
An Ethernet cross-over cable to connect the 10Base-T port on the SLC
3
ConnectReach system to the network interface card on the palmtop or
laptop (Refer to the following figure).
The network interface card needs to be configured with transport control
protocol/Internet protocol (TCP/IP) and the following TCP/IP settings:
The IP address is set to 192.168.0.2
3
The netmask is set to 255.255.255.0.
3
The Internet Explorer for Windows CE browser is recommended for use with a
palmtop. Either the Netscape or Internet Explorer browsers may be used with a
laptop. The following browser configurations should be set for EZConfig:
1. Set the homepage of the browser to: 192.168.0.1/ez. With this setting the
EZConfig program will start each time the browser is started.
2. Turn off the cache function in the browser. This will allow the screen to get
refreshed from the SLC ConnectReach system and not the browser's
cache function,
NOTE:
The configuration settings for the browser and the network interface card
are based on the SLC ConnectReach system being set to the default
settings. If the SLC ConnectReach system's settings are not defaulted,
EZConfig will not function.
363-208-050
Issue 4 June 2002 E-3