Lucent Technologies SLC ConnectReach User & Service Manual page 287

Installation
Connect Cables to the SLC ConnectReach System
Construct Cable Assemblies
Nonstandard cables
RS-232 null modem
(Continued)
The following cables are not standard and must be assembled for use with the
SLC ConnectReach system.
One or both of the following cables.
3
a. Modem cable for connection to a modem, allowing configuration
from a remote computer. This cable should have a 9-pin female
connector at the SLC ConnectReach system end and a connector
appropriate for the modem at the other end (usually a 25-pin male
connector).
b. Null-modem cable for connection to the serial port of a local
computer.
T1 modular shielded crossover cable (RJ-48C) for connection to the
3
secondary/fractional T1/DSX-1 port.
Ethernet crossover cable. Required when connecting a local provisioning
3
terminal to the 10BASE-T port which allows the use of a Web browser to
configure and/or monitor the SLC ConnectReach system.
The following figure illustrates the assembly of the required cable to connect the
SLC ConnectReach system using the RS-232 null modem connection.
363-208-050
(Continued on next page)
Issue 4 June 2002 5-35