Lucent Technologies SLC ConnectReach User & Service Manual page 231

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring QOS (Continued)
Example 2
(continued)
™
System
Step Procedure
3 When you have made the necessary configuration changes, you can
return to the Config menu by typing exit or an exclamation point (!)
(quoted as "\ |" through the SLC-2000 Access System CIT).
NOTE: The new command value takes effect as soon as you save the
configuration. You do not need to reboot the SLC ConnectReach
system to use the new value.
Stop! End of Procedure.
Issue 4 June 2002 4-145
363-208-050