Using A Web Browser To Reboot The Slc Connectreach System - Lucent Technologies SLC ConnectReach User & Service Manual

Configure/Monitor and Upgrade Software for the SLC
ConnectReach System Using a Web Browser
Executing Commands from the Main Menu
Using a Web Browser to Reboot the SLC
ConnectReach System
Performing a warm-
start reboot
The warm-start command is typically used when you have changed and saved
configuration values and want the SLC ConnectReach system to begin using the
new values. Note that if you change the starting channel of any range of voice or
data channels, you must use the cold-start command to begin using the new
values.
Using the warm-start command to reboot a SLC ConnectReach system
providing TR-08 service and feeding a SLC-2000 HDT only affects data and new
voice connections. Existing voice connections may have their speech path
interrupted for up to one tenth of a second during the restart process. During the
time it takes the system software to reinitialize and read the saved configuration
information (up to 35 seconds), new voice connections cannot be made and data
connections will be interrupted. Using the warm-start command to rebooting a
SLC ConnectReach system providing TR-303 service drops all existing calls.
To initiate a warm-start command, click the warm-start command on the
SLC ConnectReach system Main Menu (shown in the following figure). The SLC
ConnectReach system terminates your hytertext transfer protocol (HTTP) session
and reboots.
363-208-050
(Continued on next page)
8-23
Issue 4 June 2002