Lucent Technologies SLC ConnectReach User & Service Manual page 170

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Lines (Continued)
Feature codes
description
4-84 Issue 4 June 2002
™
System
This submenu is available when the BOX-features are installed and is used to set
feature codes. Feature codes must either begin with a "
local dialing plan. Codes that do not start with a "
pulse phones. This setting is system wide. The following table provides a listing of
the feature codes configuration commands that can be entered at the
config:Line:feature-codes prompt.
To Modify the Feature Code
for
Canceling call waiting
Call pickup
Directed call pickup
Call forwarding
Canceling call forwarding
Initiating a page
Direct trunk access
Analog trunk or line access
Canceling the redial on busy
The feature codes are described as follows:
Cancel call
waiting
Call pickup
Direct call pickup This feature allows call pickup outside the answerer's
Call forward
variable
*
" are required for rotary dial
Enter this command followed by the
new code
cancel-call-waiting
call-pickup
direct-call-pickup
call-forward-var
cancel-forward-var
pager
digital-direct-access
analog-direct-access
cancel-busy-redial
This feature code disables call waiting for the next call.
Dialing the call pickup feature code causes a ringing
line in the user's pickup group to be answered.
pickup group.
This feature forwards calls from one extension to
another extension or trunk. Calls coming from a
loop-start trunk cannot be forwarded to a loop-start
trunk. An incoming call may be forwarded as many as
forty-seven times. If there is a warm-start, call forward
variable will default to the systems settings; the user's
settings will be lost.
363-208-050
*
" or must be within the
Default
Setting
*70
*1
*5
*72
*73
*3
*40
*41
*42
(Continued on next page)