Lucent Technologies SLC ConnectReach User & Service Manual page 424

Software Upgrade, Maintenance, and Trouble Clearing
Maintenance Procedures
Upgrading the SLC ConnectReach System
with New Software (Continued)
Software upgrade
from the network
(continued)
9-10 Issue 4 June 2002
Custom Network Upgrade
The DNS server must be configured and enabled for the network-upgrade to
function. Refer to Chapter 4, "Configuring the SLC
for information on configuring the DNS server. To specify a particular Internet
protocol (IP) address or software release, proceed as follows:
Step Procedure
1 At the Main Menu prompt, enter the network-upgrade command:
> network-upgrade
2 At the network-upgrade prompt, enter the commands shown in the
following table.
Enter this
command...
server-ipaddr
version
user
password
host-download-
directory
prepare
download
3 Enter the save command to save the new settings. The prepare
command will restore the settings to the last saved values.
4 To save the settings enter the save command
(Network-upgrade)> save
®
ConnectReach
...and specify
this value Comments
Host name or IP address of the
network upgrade server to which
name, ip-addr
the software is to be downloaded.
Version of the software.
rel
Username valid on the network
upgrade server. For Lucent's FTP
username
site, username = anonymous.
Password for the username. For
Lucent's FTP site, password =
password
your email address.
The directory where the software
/t1-int/
release
files will be stored.
363-208-050
™
System",
(Continued on next page)