Lucent Technologies SLC ConnectReach User & Service Manual page 199

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Configuring Routes (Continued)
Configuring routes
(continued)
Example of default
and static routes
™
System
Default (cont.)
BackupDefault
Route
NOTE:
The default route must be set to the Internet access location for a
successful Internet connection.
The following figure provides an example of default and static routes.
To direct the default IP traffic to an alternate router, the
user can enter:
default GW IPaddrOfGw
Where IPaddrOfGw is the IP address of the router.
To disable default routing on the SLC ConnectReach
System, enter the default none command.
This command lets you set up a backup default
interface. The options are the same as those for the
default command. To disable backup default routing
on the SLC ConnectReach system, enter the
backupDefault none command.
This command allows the user to add or delete static
routes through any IP gateway. For convenience, the
user may specify WAN or PVCn instead of an IP
gateway address. The WAN and PVCn options have
the same definitions as they did in the default
command. To specify a router on the Ethernet as the
next hop, use the GW option followed by the IP
address of the router.
(Continued on next page)
Issue 4 June 2002 4-113
363-208-050